Liberty Tool Visit

First visit this trip to Maine….got a switch panel I needed for 3ph rotary converter setup.  A nice yet unmarked 3″ sine bar a few little vee blocks and some nice ground lathe bits.  Coil was 75 cents so I took a chance it might work on my Rivett brake…no dice.  A little research shows it is more than likely for an early mag starter.  All this stuff plus the Rockwell Carbide Tool Grinder project from previous post… $29!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.