A few finds from Dempsey and Co visit this morning.  Needed a tilting table so that worked out well. Convex radii tool was a bonus althought not sure fits the lathe yet.  Will try that out later.

Tilting table is a nice 12x8 with what looks like a swivel base.  Will clean it up and post updates.

Looks like snow inside and out today.  Did a fair amount of squaring on the mill today.  Used fly cutter and an end mill.  Still getting used to fly cutter ... getting bit ground right has been most of the challenge.  Mill size a bit if a challenge as well.

Fired up the horizontal mill and cut a few blocks for holding seat and chain stays.  Slotting on mill experiment coming next.

Just cuz I wanted to expand my limited lathe experience so what the hell.  Learned about turning and boring aluminum as well as parting.

Always a great time visiting Liberty Tool Co

Funished miters ht/dt and bb shell cuts....will work on top tube next...

New fixed gear commuter underway.

Spiders from mars in progress...