Sculpture, Machines, Bicycles, IoT, Attention Deficit Disorder
A few finds from Dempsey and Co visit this morning. Needed a tilting table so that worked out well. Convex radii tool was a bonus althought not sure fits the lathe yet. Will try that out later.
Tilting table is a nice 12×8 with what looks like a swivel base. Will clean it up and post updates.
Looks like snow inside and out today. Did a fair amount of squaring on the mill today. Used fly cutter and an end mill. Still getting used to fly cutter … getting bit ground right has been most of the challenge. Mill size a bit if a challenge as well.
Fired up the horizontal mill and cut a few blocks for holding seat and chain stays. Slotting on mill experiment coming next.
Just cuz I wanted to expand my limited lathe experience so what the hell. Learned about turning and boring aluminum as well as parting.
Always a great time visiting Liberty Tool Co
Funished miters ht/dt and bb shell cuts….will work on top tube next…
New fixed gear commuter underway.
Spiders from mars in progress…