Prototype hooks coming together for bike rack. Drilled holes in the brackets. Continue the hook prototyping this weekend.
Latest Update on Campy Repair Stand
Paint stripper, sand paper, and some elbow grease have this stand almost ready to paint…
Campy Ferrule for Delta Brake
Here you go Wayne. I still think the brass one was cooler. This concludes the obscure Campy parts (see previous post for Campy repair stand) day in the shop.
Campy Repair – All fabrication Complete
Finished up all the fabrication repair. Brazed the crack in the joint near clamp and brazed the hinge back on the clamp. Also got the adjustable clamp locking mechanism freed up.
Next step is to prep for paint and bring back to showroom standards.
Heat Solves Stuck – Campy Repair Stand Disassembled
I have “un stuck” many a rusty joint but I am always still amazed when something is rusted solid and seemingly welded together falls apart with heat.
Campy Repair Stand in Disrepair
All the parts are together again…need to weld up the hinge and free up the rusted joints so it can be broken down.
Joe Bringhelli Main Tube Miter Jig
After making a few modifications to the jig I have it setup on the tilting table. Did a couple of practice cuts and all went smooth.
Next up I will work on tube length, alignment and angles.
Tilting Table all Cleaned Up
It has a lip screwed on to the base I need to remove…frozen/stripped screws. EZ Out in my future.
Ordered assortment of t-nuts and such so should be able to attach this weekend. Goal to have Bringhelli jig mount by end of weekend.
Tilting Table with Swivel Base part 2
Could not help myself..did a closer look at the table and took a few more shots. Can not find a mark on it bit appears to be very well made.
As expected the radii tool from previous post is too big for my lathe…solution…start looking for bigger lathe:)
Angle Table with Swivel Base and Convex Radii Tool
A few finds from Dempsey and Co visit this morning. Needed a tilting table so that worked out well. Convex radii tool was a bonus althought not sure fits the lathe yet. Will try that out later.
Tilting table is a nice 12×8 with what looks like a swivel base. Will clean it up and post updates.